Hello Troy,
Thank you for posting your query on Microsoft Community Forum.
AS per the description I understand you are getting “internal error: gedit3” while using AutoCAD LT 2002.
Which version of Windows 7 is installed on your computer?
Let’s try these methods to get this problem resolved.
Method 1:
There could be possibility of some background program conflicting with the program, let’s put the computer in clean boot and see if the issue persists.
How to perform a clean boot to troubleshoot a problem in Windows 8.1, Windows 8, Windows 7, or Windows Vista
http://support.microsoft.com/kb/929135/en-us
Note: Refer "How to reset the computer to start as usual after troubleshooting with clean boot" under more information to reset the computer to start as normal after troubleshooting
Method 2:
If the above method does not solve the problem, most probably this could be the compatibility issue with Windows 7.
We can try to run the program in Compatibility mode and check.
Make older programs run in this version of Windows
http://windows.microsoft.com/en-in/windows7/make-older-programs-run-in-this-version-of-windows
Also, please refer to the suggestion from michele_coser on 11-12-2012 08:59 AM
http://forums.autodesk.com/t5/AutoCAD-LT-General/Autocad-LT-2002-Gedit-Error/m-p/3696176#M110148
Method 3:
If none of the suggestions above helps you enough to solve the problem, I would suggest you to post your query on the following Forum to get refined and appropriate suggestions.
AutoCAD LT General
http://forums.autodesk.com/t5/AutoCAD-LT-General/bd-p/43
Hope this helps, please revert for any for any further assistance.
Thank you
