Reset Network Adapters using CMD

Split from this thread.

how do you reset network adaptors using command promt

Hi KHUMO N MAKUKUMAKUKU,
Open PowerShell or Command Prompt and run as administrator, type the following commands by pressing enter at the end of each command line:
netsh winsock reset
     netsh int ip reset
     netsh advfirewall reset
   ipconfig / flushdns
    ipconfig / release
    ipconfig / renew
  Close and restart the computer at the end of all the commands.

274 people found this reply helpful

·

Was this reply helpful?

Sorry this didn't help.

Great! Thanks for your feedback.

How satisfied are you with this reply?

Thanks for your feedback, it helps us improve the site.

How satisfied are you with this reply?

Thanks for your feedback.

 
 

Question Info


Last updated February 21, 2025 Views 169,832 Applies to: