restoring windows 7's master boot sector to original state after deleting linuxmint 9 isadora from system

hello... good day everyone...

please help me repair my windows 7 installation after deleting the partition of linuxmint 9 isadora from the system

i can't run my system... boot always at error...

 

*** Email address is removed for privacy ***

 

Question Info


Last updated March 20, 2018 Views 7,876 Applies to:
Answer
Answer

How to repair and reboot to Windows 7:

Note: Linux users, steps c, d and e may vary, post back if you can not complete these steps.

a) Insert the Windows 7 System Repair DVD or Installation DVD and reboot.

b) Select the correct keyboard input method and click ‘Next’.

Note: If you are using the Windows7 Install DVD then at the 'Install Now' prompt (Do not pick the Install Now option) instead choose the 'Repair your computer' option located in the lower left of the display.

c) The System Repair tool will search for a valid operating system and will report that “Windows found problems with your computer’s startup options. Do you want to apply repairs and restart your computer?”

d) Click ‘Repair and restart’ and reboot again to the Windows 7 System Repair environment.

e) Click ‘Next’ at the keyboard selection prompt and when the ‘System Recovery Options’ screen appears verify that the “Use recovery tools that can help fix problems starting Windows” is selected.
Note that on your Dual Boot system there now should be only one operating system listed. Click the ‘Next’ button.

f) Now from the menu list select the ‘Command Prompt’ option.

g) At the DOS prompt type the following three commands:

bootrec.exe  /fixmbr

bootrec.exe  /fixboot (may return an 'Eliment not found' message)

bootrec.exe  /RebuildBcd

h) Close the command prompt window and click the ‘Startup Repair’ option.

i) The repair process may take some time, so wait until the process completes at which point you will see two messages “Windows cannot repair this computer automatically” and “Startup Repair cannot repair this computer automatically”.

These messages are the result of the radical changes made by removing the other drive. Ignore the Send/Don’t send options.

J) Close this message window by clicking on the X in the upper right corner of the Send/Don’t send window. Next click on the ‘View advanced options for system recovery and support’ option and from the main menu once again click ‘Startup Repair’. This time the repair process may only that a few seconds and when prompted “Startup Repair could not detect a problem”, click ‘Finish’  and run the ‘Startup Repair’ option one more time, click ‘Finish’, and then remove the System Repair DVD and click ‘Restart’.  Reboot the computer.

JS
http://www.pagestart.com


Never be afraid to ask. This forum has some of the best people in the world available to help.
Never be afraid to ask. This forum has some of the best people in the world available to help.

Did this solve your problem?

Sorry this didn't help.

Great! Thanks for marking this as the answer.

How satisfied are you with this reply?

Thanks for your feedback, it helps us improve the site.

How satisfied are you with this response?

Thanks for your feedback.