"No disk that can be used for recovering the system disk can be found"

I am try to restore an system image from a 160G hard drive to a new 320G hard drive using a repair disk I made on the same computer.
 After the repair loads , it finds my restore image on D drive, the 320G drive is not checked in the excluded window.
When i start the restore, I get "No disk that can be used for recovering the system disk can be found".
I have even installed win 7 on the new 320 drive in hopes that it would allow the recovery, it does not......
 
Question Info

Last updated July 20, 2018 Views 77,212 Applies to:
Answer
I finally just got it working.  Trying to go from a 500gb drive to another 500gb drive and getting the same error.  I went into Diskpart and type "select disk=0".  Then I type "detail disk" to make sure I had the right drive.  I typed "Clean", and then "exit" to get out of Diskpart.  And then I started the image recovery and finally it works.  Before I did these commands I had formatted the drive to one large partition, set the partition to active, and made sure it had a drive letter assigned.     

131 people were helped by this reply

·

Did this solve your problem?

Sorry this didn't help.