Blue screen of death


i have my computer for 3 months already and i already had  BSOD  3 times, 2 of the were today

could you please help me figure out what my problem is?

here are the zipped dump files:

these are my systems' tech specs:

intel core i7 4770

gigabyte ultra durable 4 motherboard

16gb of ram

gainward nvidia geforce gtx 760 with 4gb of dedicated video ram

Thank you very much

Moved from Windows 7 Devices and Drivers Forum.



We have two bug checks:


This indicates that a system thread generated an exception which the error handler did not catch.

BugCheck 1000007E, {ffffffffc0000005, fffff800035247f2, fffff8800a5f4858, fffff8800a5f40b0}

The 1st parameter of the bug check is 0xc0000005 which indicates an access violation occurred.

0: kd> .exr 0xfffff8800a5f4858
ExceptionAddress: fffff800035247f2 (nt!RtlInterlockedClearBitRunEx+0x00000000000000b2)
   ExceptionCode: c0000005 (Access violation)

The violation occurred in nt!RtlInterlockedClearBitRunEx.


This indicates that Microsoft Windows or a kernel-mode driver accessed paged memory at DISPATCH_LEVEL or above.

This bug check is issued if paged memory (or invalid memory) is accessed when the IRQL is too high. The error that generates this bug check usually occurs after the installation of a faulty device driver, system service, or BIOS.


Please run Memtest for NO LESS than ~8 passes (several hours):


Download Memtest86+ here:

Which should I download?

You can either download the pre-compiled ISO that you would burn to a CD and then boot from the CD, or you can download the auto-installer for the USB key. What this will do is format your USB drive, make it a bootable device, and then install the necessary files. Both do the same job, it's just up to you which you choose, or which you have available (whether it's CD or USB).

Do note that some older generation motherboards do not support USB-based booting, therefore your only option is CD (or Floppy if you really wanted to).

How Memtest works:

Memtest86 writes a series of test patterns to most memory addresses, reads back the data written, and compares it for errors.

The default pass does 9 different tests, varying in access patterns and test data. A tenth test, bit fade, is selectable from the menu. It writes all memory with zeroes, then sleeps for 90 minutes before checking to see if bits have changed (perhaps because of refresh problems). This is repeated with all ones for a total time of 3 hours per pass.

Many chipsets can report RAM speeds and timings via SPD (Serial Presence Detect) or EPP (Enhanced Performance Profiles), and some even support changing the expected memory speed. If the expected memory speed is overclocked, Memtest86 can test that memory performance is error-free with these faster settings.

Some hardware is able to report the "PAT status" (PAT: enabled or PAT: disabled). This is a reference to Intel Performance acceleration technology; there may be BIOS settings which affect this aspect of memory timing.

This information, if available to the program, can be displayed via a menu option.

Any other questions, they can most likely be answered by reading this great guide here:



Debugger/Reverse Engineer.

Was this reply helpful?

Sorry this didn't help.

Great! Thanks for your feedback.

How satisfied are you with this reply?

Thanks for your feedback, it helps us improve the site.

How satisfied are you with this reply?

Thanks for your feedback.


Question Info

Last updated December 26, 2017 Views 57 Applies to: