"No disk that can be used for recovering the system disk can be found"

I am try to restore an system image from a 160G hard drive to a new 320G hard drive using a repair disk I made on the same computer.
 After the repair loads , it finds my restore image on D drive, the 320G drive is not checked in the excluded window.
When i start the restore, I get "No disk that can be used for recovering the system disk can be found".
I have even installed win 7 on the new 320 drive in hopes that it would allow the recovery, it does not......
Answer
Answer
I finally just got it working.  Trying to go from a 500gb drive to another 500gb drive and getting the same error.  I went into Diskpart and type "select disk=0".  Then I type "detail disk" to make sure I had the right drive.  I typed "Clean", and then "exit" to get out of Diskpart.  And then I started the image recovery and finally it works.  Before I did these commands I had formatted the drive to one large partition, set the partition to active, and made sure it had a drive letter assigned.     

198 people found this reply helpful

·

Was this reply helpful?

Sorry this didn't help.

Great! Thanks for your feedback.

How satisfied are you with this reply?

Thanks for your feedback, it helps us improve the site.

How satisfied are you with this reply?

Thanks for your feedback.

 
 

Question Info


Last updated March 6, 2021 Views 98,284 Applies to: